Greenlee SITE-RITE 840A Mode D'emploi page 3

Bending — Handle Up
PRESSURE HERE
1. Mark the conduit.
2. Insert the conduit into the bender so that the arrow is aligned with
the bending mark.
3. Place one foot on the bender as illustrated. Use heavy foot pressure
on the bending shoe; maintain this pressure throughout the bend.
4. Look down the line of sight as illustrated. Stop bending when the
pin is in line with the appropriate angle mark.
Note: Overbend rigid conduit slightly to compensate for springback.
Bending — Handle Down
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
APPLY FOOT
90° 60° 45° 30° 22-1/2° 10°
FLOOR LINE
10° 22
SITE-RITE
LINE OF
SIGHT
PIN
1
/ °
2
30°
45°
60°
90°
Hand Benders
®
ARROW
45°
3