Installing Extra Ventilation Hose; Starting And Stopping The Dust Extractor - Husqvarna HTC D80 Manuel De L'opérateur

Usage
To connect two camlock adaptors, push the male and female adaptors into each other
and tighten both of the tensioning arms.
4.5

Installing extra ventilation hose

To improve the air while grinding, an extra ventilation hose can be installed on the dust
extractor. This extra ventilation option should be used while grinding floors that give
rise to toxic gases or if the room is very poorly ventilated.
Tip!
Only use the extra ventilation hose, which at the least must have ø 160 mm,
when necessary, since the dust extractor's capacity is reduced when the hose is
installed.
Figure 4-8. Installation of extra ventilation hose
Note!
Place the free end of the ventilation hose outdoors by pulling it through a
window or a door.
4.6

Starting and stopping the dust extractor

Note!
Check that all the sliding valves are in the open position.
1. Place the dust extractor where you want to start the vacuuming work.
2. Connect the dust extractor to the mains supply. Use cables suitable for the dust
extractor (see minimum cable area in Technical data, page 50).
3. Start the dust extractor, by pressing button "I" or button "1" on the transmitter, if
the dust extractor is equipped with the Remote Start option.
20
HTC D80
1.1