General Informations; Additional Safety And Working Instructions; Technical Data; Specifi Ed Conditions Of Use - Milwaukee M12 PL Notice Originale

1 GENERAL INFORMATIONS

1.1 Additional safety and working instructions

Always check the work area before beginning a job. Do not allow the tool to contact electrical, chemical, or
moving hazards.
Do not try to replace the battery pack if the surface of the instrument is wet.
Do not dispose of used battery packs in the household refuse or by burning them. Milwaukee Distributors off er to
retrieve old batteries to protect our environment.
Do not store the battery pack together with metal objects (short circuit risk).
Use only System M12 chargers for charging System M12 battery packs. Do not use battery packs from other systems.
Battery acid may leak from damaged batteries under extreme load or extreme temperatures. In case of contact
with battery acid wash it off immediately with soap and water. In case of eye contact rinse thoroughly for at least
10 minutes and immediately seek medical attention.
Warning! To reduce the risk of fi re, personal injury, and product damage due to a short circuit, never immerse
your tool, battery pack or charger in fl uid or allow a fl uid to fl ow inside them. Corrosive or conductive fl uids, such
as seawater, certain industrial chemicals, and bleach or bleach containing products, etc., Can cause a short
circuit.
This appliance is not intended to be used or cleaned by persons with reduced physical, sensory or mental
capabilities, or lack of experience or knowledge, unless they have been given instructions concerning the safe
use of the appliance by a person legally responsible for their safety. They should be supervised whilst using the
appliance. Children shall not use, clean or play with this appliance, which when not in use should be secured out
of their reach.
Chemical Burn Hazard. This device contains a lithium button/coin cell battery. A new or used battery
can cause severe internal burns and lead to death in as little as 2 hours if swallowed or enters the
body. Always secure the battery cover. If it does not close securely, stop using the device, remove the
batteries, and keep it away from children. If you think batteries may have been swallowed or entered
the body, seek immediate medical attention.

1.2 Technical data

Battery voltage ....................................................................................................... 12 V
Weight according EPTA-Procedure 01/2014 (2.0 ... 6.0 Ah) ..................... 2.56 ... 2.8 kg
Frequency band(s) of Bluetooth ................................................................ 2402-2480 MHz
Radio-frequency power ......................................................................................... 1.8 dBm
Bluetooth version ........................................................................................ 4.0 BT signal mode
Recommended ambient operating temperature .............................................. -18 .... +50 °C
Recommended battery Type ................................................................................ M12B...
Recommended charger Type ..................................................................C12C, M12C4, M12-18...
1.3 Specifi ed conditions of use
The PIPELINE LOCATOR is designed to locate the sonde position and trace the push cable of
the Milwaukee PIPELINE INSPECTION SYSTEMS REEL.
Do not use this product in any other way as stated for normal use.

1.4 Radio frequency interface requirements - related to European installation

Note: This equipment has been tested and found to comply with the limits for a EN 300 440 v2.1.1 receiver
Category 3.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment is sensitive to other equipment that intentionally generates, radio frequency energy in the 2402-
2480MHz that may conduce to the instability to use the remote control on it. However there is no guarantee that
interference will not occur in a particular installation. If this equipment suff er from the harmful interference from
another radio device to radio this can be determined by turning the respective equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Turn off the disturbance equipment
- Increase the separation between the disturbance equipment
- Consult the dealer or an experienced radio technician for help
ENGLISH 2