Technical Data - IEH FlammEx profi 003929 Mode D'emploi

Table of functions:
Sound Green Power LED Red Alarm LED
none fl ashes every 60 s off
beeps every 60 secs off off
beeps every 60 secs off off
beeps every 2 secs fl ashes every 2 s fl ashes every 2 s
beeps every 60 secs off off
beeps every 60 secs fl ashes every 60 s fl ashes
intermittent alarm off fl ashes
6. Maintenance
Changing the battery:
The batteries should be changed at least once a year or immediately if the low battery alert
sounds. When changing the batteries, the alarm must not be dismounted.
1. Open the battery compartment by pressing the release (picture 5a) while at the same time
sliding the compartment cover downwards (picture 5b). Do not dispose of the batteries with
your household waste. The end user must recycle all used batteries. Batteries may be
returned free-of-charge to the place of sale or to your local collection point.
2. Insert 3 new batteries the right way round (picture 6) and make sure that the red pins are
in contact with each battery. The alarm confi rms that the batteries are in place with a short
beep.
3. Close the battery compartment by placing the cover on the alarm and sliding it upwards
until it click in.
4. Test the alarm straightaway (see Operating test).
We recommend the following 1.5 V alkaline batteries, size AA/Mignon:
Duracell MN 1500, Energizer E91
Under normal conditions new batteries will last for around a year – depending on the number
of tests. If the alarm is subjected for prolonged periods to high or low temperatures, or to
high air humidity, then the batteries' useful life will become shorter.
Yellow Fault LED Meaning
off working normally
fl ashes every battery low, see 6. Maintenance
60 secs
constantly lit alarm is not locked into
mounting plate
fl ashes every 2 s test function
fl ashes 3 x device faulty, replace
every 60 s immediately
off muted
off alarm triggered, see section 3
8
Testing the alarm:
Check once a week that the alarm is working properly by briefl y pressing down the Test/
Mute button (picture 5b). The alarm will beep 2 or more times and the 3 LEDs (picture 5c)
will light up briefl y. Afterwards the alarm returns to its normal operating mode.
Cleaning the alarm:
Loose dust inside the alarm can be sucked out through the vents using a vacuum cleaner.
The alarm cover can be cleaned from the outside with a lightly dampened cloth. Under no
circumstances use any domestic cleaners containing ammonia or any other chemicals
(such as cleaning agents or solvents) on or anywhere near the alarm. Do not get paint or
varnish on the alarm!

7. Technical data

Battery operated 3 x 1.5 V alkaline (AA/Mignon)
Calibrated acc. to EN 50291
Alarm volume approx. 85 dB/3 m
Size Ø 125 mm, height 33 mm
Life approx. 5 years
Trigger level in accordance with EN 50291:
CO concentration in air
50 ppm
100 ppm
300 ppm
Subject to technical and design changes without prior notice.
IEH GmbH
An der Strusbek 40
22926 Ahrensburg/Germany
Internet: www.fl ammex.de
E-Mail: info@fl ammex.de
No. minutes before alarm triggered
60 - 90
10 - 40
3
9
5 years
guarantee