Operation; Setting Up And Turn On The Scale; Zeroing The Display; Taring - Adam Equipment CBK Serie Mode D'emploi

EN

2.0 OPERATION

2.1 SETTING UP AND TURN ON THE SCALE

The CBK, CBK-M series of scales provides a range of accurate, fast and versatile weighing scales with
counting, percent weighing and check-weighing functions. For the first time, you should set up your scale as
follows:
Gently Place the platform in the locating holes on the top cover. Level the scale by adjusting the four feet.
The scale should be adjusted such that the bubble in the spirit level is in the centre of the level and the scale
is supported by all four feet.

2.2 ZEROING THE DISPLAY

You can press the [Zero] key at any time to set the zero point. When the zero point is obtained the display
will show the indicator for zero.
The scale has an automatic re-zeroing function to account for minor drifting or accumulation of material on
the platform. However you may need to press [Zero] to re-zero the scale if small amounts of weight are still
shown when the platform is empty.

2.3 TARING

Manual tare
Steps:
Zero the scale by pressing the [Zero] key if necessary. Place a container on the platform, a value for its
weight will be displayed.
Press the [Tare] key when reading is stable. The weight that was displayed is
stored as the tare value. The stable and "NET" indicator will be on. As a product
is added only the weight of the product will be shown. The scale could be tared
a second time.
When the container is removed a negative value will be shown. The zero indicator will also be on
because the platform is back to the same condition as it was when the [Zero] key was pressed last.
Press [Tare] or [Zero] to remove the tare value and display zero. The Net indicator will disappear.
© Adam Equipment Company 2017
Attach the power cable to the connector on the base on the left of the scale
Plug in the power cable to the mains. Switch on the power switch located on
the base on the right side of the scale.
The scale will first display the software revision then run a self-
test. At the end of the self-test it will display zero weight when a
stable condition has been achieved. A stable symbol and zero
symbol indicators are also displayed.
2