Installation; Reverse The Door; Operation; Thermostat - Polar CE322 Mode D'emploi

Telephone Helpline: 1300225960

Installation

Note: If the unit has been moved or not stored in an upright position, let it stand upright
for approximately 12 hours before operation. If in doubt allow the appliance to stand.
Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are
1.
thoroughly removed from all surfaces.
Maintain a distance of 2cm between the unit and walls or other objects for ventilation.
2.
Note: Before using the appliance for the first time, clean the shelves and interior with
soapy water.

Reverse the Door

Disconnect the appliance from the power supply.
1.
Tip the appliance back slightly to gain access to the
2.
lower hinge.
Unscrew the lower hinge and pivot pin. Remove from
3.
the door.
Carefully lower the door and remove it from the
4.
appliance.
Unscrew the upper pivot pin from the appliance and slot
5.
it in to the opposite side. Secure with the two screws.
Slot the door back on to the upper pivot pin.
6.
Slot the lower hinge and pivot pin back in to the bottom of the door.
7.
Screw the lower hinge back on the appliance with the two screws.
8.
Note: The fixings must use the holes on the other side of the hinge when switching sides
[Fig. 1].

Operation

Thermostat

The thermostat is located in the interior cabinet [Fig. 2].

Turn On

Set the temperature to the desired setting:
1.
1 (8°C) to 6 (0°C).
Note: Setting the switch to '0' turns off the
appliance.
Close the door of the appliance.
2.
Connect the appliance to a mains power supply.
3.
Fig. 1
Fig. 2
2