Manual Operation - Renkforce 1359969 Mode D'emploi

Fader Reversal
With this function, you can reverse the fader path of the channel fader (18) and the joystick PAN/TILT (13).
• Press the FINE (15) and MODE (14) buttons at once until the CHASE COMBINE LED below the display (6)
lights up.
• Select the desired light effect with the respective SCANNERS (1) button.
• First use the FADE TIME (16) fader to select the desired DMX controller channel to be reversed. The
channel is indicated on the display (6).
• Then use the SPEED fader (17) to select Y or N. Y means that the channel fader selected is inverted, N
means that it is not inverted.
• Push the button MIDI/REC (5) to save the settings.
• Repeat the operating steps for all other channels that are to be changed and save the settings with MIDI/
REC (5).
• Finally, push the FINE (15) and MODE (14) buttons twice at the same time to leave the settings.
b) Manual operation
For this operating mode, the effect lights are manually controlled via the channel fader (18) and the joystick
PAN/TILT (13).
The settings in this operating mode cannot be saved.
• Press the AUTO/DEL button (7) until the mode display (8) MANUAL lights up. This activates manual mode.
• Select the desired light effect with the respective SCANNERS (1) button.
• Influence the function of the light effect via the respective channel faders (18) and the joystick
PAN/TILT (13).
• Press the PAGE SELECT A/B (19) button to control first 10 channels (LED A is lit), the second 10 channels
(LED B is lit) or all channels at once (LEDs A and B are lit).
• Push the button TAP DISPLAY (10) to briefly switch the display (6) from the display of DMX values (0-255)
to display of the percentages (0-100%). If the value of a DMX channel is changed again then, the display
will switch back to displaying the DMX values.
39