Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Install Mounting Brackets
4
Raise the fan to the mount. Insert one rubber bumper between
the mounting plate and the loosely installed mounting bracket
with the 6 mm nylock nuts.
Secure the other bumper with the remaining mounting bracket
and nuts (Fig. 4).
Tighten all hardware.
Fig. 4
Mounting
Bracket
6 mm Nylock
Nut
20
Install Wiring Cover
5
Raise the wiring cover, allowing about a 1/8" (3 mm) gap at the
ceiling. Align the mounting slots with the screw holes on the
extension tube, and secure it with the wiring cover screws.
Slide the trim up the extension tube, aligning the tabs on the
inside with the slots on the bottom of the wiring cover. Twist
clockwise to snap the trim into position (Fig. 5).
Fig. 5
Wiring
Cover
Screw
Wiring Cover
Trim
REV. H
Screw
|
© 2018 BIG ASS FANS
|
ALL RIGHTS RESERVED
Publicité
Table des Matières
