RCA Symphonix RPSA05A Mode D'emploi page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USER GUIDE
What is the wide tube for?
volume than the thin tubes. Before installing the wide tube,
we recommend that you try a thin tube at all three volume
levels (see page 7 for information on adjusting the volume).
If you want still more volume than the third level, follow the
instructions below to install the wide tube.
To change the tube:
1.
Find the part of the tube that
attaches to the earpiece.
Gently rotate this section of the
tube so that the sound inlet is
exposed (as shown here).
2.
Pull the tube straight off the
earpiece.
Note: If you're installing the wide
tube, you can skip steps 3 and 4.
3.
Once you've removed the tube
completely, gently pull the
dome from the end of the tube.
4.
Find the other thin tube that came in the package.
Attach the dome to the end of this tube by pushing
the opening on the back of the dome gently onto
the end of the tube. Push the dome onto the end of
the tube as far as it will go. Make sure the dome is
securely fastened.
5.
Before you attach the tube to the earpiece, make
sure the exposed part of the earpiece is clean of dust
or other particles.
6.
Find the part of the tube that
connects to the earpiece
(shown here).
Note: A thin tube is shown here for
illustration. Step 6 applies for the
wide tube as well.
3
The wide tube provides more
IMPORTANT: DO NOT pull
the tube off at an angle.
Doing so could harm the
tube connector or the
components in your earpiece
and void your warranty.
Dome
Sound inlet
Tube connector

Publicité

Table des Matières
loading

Table des Matières