How To Install The Single Ir Emitters - Philips RFX9200 Guide De Démarrage

2.4

How to Install the Single IR Emitters

The Single IR emitters can be used in combination with, or as an alternative to the front
blaster.
Plug the Single IR emitters into the Extender.
Attach the Single IR emitters to a neighboring surface facing the IR receiver (for aesthetic
purposes or when it is difficult to locate the IR receiver).
–or–
Attach the Single IR emitters directly to the IR receivers of your devices.
Make sure the Single IR emitters are connected properly and that they are placed within
range of the IR receivers of the A/V devices.
D Note
The front blaster is an additional addressable IR port. The IR signals are not sent via
IR emitters but through the front of the Extender. That way it allows you to control
projectors and IR-receivers which are placed outside the rack or closet.
How to Install the Extender
9