Scott Safety Sari Instructions D'utilisation page 15

18
3. Selection
Sari + filter
Breathing protector equipped with filter
Type of protective device
Full face mask with particle filter P3
Full face mask with gas filter *)
Device with combined filter
*) Provided that the maximum permissible detrimental gas concentration for the gas filter is not exceeded. For
non-powered filtering devices with gas filter, concentration must not exceed 0.1 vol.% in gas filter class 1 and 0.5
vol.% in gas filter class 2 and 1.0 vol.% in gas filter class 3.
**) If national guidelines exist: in all cases the lowest value applies.
Note! In Australia only, the following limitations apply:
Provides P3 protection
Provides P2 protection with a half face respirator negative pressure respirator
Sari + blower device
Blower-assisted breathing protector equipped with filter
Type of protective device
Power-assisted full face mask with
particle filter TM3P
Power-assisted full face mask with
gas filter *)
TM3 gas filter class 1, 2 or 3
Device with combined filter
*) Provided that the maximum permissible detrimental gas concentration for the gas filter is not exceeded. For
power-assisted filtering devices with gas filter, concentration must not exceed 0.05 vol.% in gas filter class 1 and
0.1 vol.% in gas filter class 2 and 0.5 vol.% in gas filter class 3.
**) If national guidelines exist: in all cases the lowest value applies.
Kesaf
Type of protective device
Compressed air-line breathing
apparatus with full face mask +
Flow control valve CV
4. Use, and Donning
See Instructions for Use of the filter and the blower device to be used.
Check before use

intactness of facepiece, rubber parts and visor

head harness condition and elasticity

that speech diaphragm is in place

that exhalation valve is in place and that its cover is properly fastened

that inh. and exh. valves function properly

that the filter is correct for the intended use (filter type and class)

that storage period of the filter has not been exceeded

filter condition and intactness. Shake the filter to ensure that there are no loose components/contents. The
filter shall be replaced if it has been exposed to strong press or impact. It may be damaged, also by a fall on
a hard surface, also when attached to a mask / blower device.
Multiples of threshold concentration **)
APF (Assigned protection factor)
BS 4275 (GB) BGR 190-ZH1/701 (DE)
40 400
20 400
The specified multiples of threshold value for the gas or particle filters
are given separately, but in all cases the lowest value applies
only with a full face
Multiples of threshold concentration **)
APF (Assigned protection factor)
BS 4275 (GB) BGR 190-ZH1/701 (DE)
40 500
40 500
The specified multiples of threshold value for the gas or particle filters
are given separately, but in all cases the lowest value applies.
Multiples of threshold concentration **)
APF (Assigned protection factor)
BS 4275 (GB) BGR 190-ZH1/701 (DE)
100 1000
Remarks, limitations
Particles
Filter types A, B, E, K, AX, SX, Hg-P3 and NO-
P3 have different applications. For more
information, see Instructions for Use of Scott
Safety filters.
respirator (AS/ NZS
Remarks, limitations
For devices with combined filter apply the
relevant limitations of gas and particle filters.
Remarks, limitations
15
1716:2012 refers).