Publicité
Les langues disponibles
Les langues disponibles
Handle
Soap Dish
Middle
Receptacle
Locking
Lever
Suction Cup Feet
assembly instructions
1.
Remove contents from carton.
2.
Place transfer bench frame on its side.
Unfold one leg section by extending outward.
Locking pins (2) will snap into place when legs
are secure. Make sure both locking pins fully
protrude through the holes.
3.
Repeat for second leg section.
4. Stand transfer bench upright. Insert backrest
into backrest receptacle on back of the seat.
Push down firmly to secure in place.
5.
Attach red handle by inserting handle into
the two receptacle holes on the side of the
seat. Be sure that curve of handle is facing
out. Note: handle should be inserted on the
same side as the large suction cup feet.
Secure in place by inserting the two (2) red
locking knobs from the bottom and turning
clockwise until tight.
6.
Insert soap dish on same side as red handle
by sliding into middle receptacle from the
top down.
Rev.2.07.23.14
Backrest
Backrest
Receptacle
Lock Pins
Seat
Positioning
Lever
Locking
Lever
Small Rubber Feet
operation
1.
Place transfer bench in tub so the suction cup
feet are INSIDE the tub. (If the preference is
for the seat to face the opposite way, legs can
be switched to the other side of the bench by
depressing brass push pins, removing legs
and inserting them into the opposite leg
receptacles.)
2.
Adjust height of legs to desired height by
depressing brass push pins and setting to
proper height. Note: Legs should be set to
ensure seat is level, taking into account that
the legs inside the tub will have to be set to a
lower height setting because of the difference
in height from most tubs to floors.
3.
To move seat, pull the red seat positioning
lever located under the seat away from the
frame and slide seat until it clicks into place.
Note: there are two (2) positions where seat
will be secured to frame, one on the left side
and one on the right side.
folding
To fold for storage or transport, stand bench
vertically on one set of legs. On one side of leg
assembly, pull both red locking levers away from
frame simultaneously until both locking pins
disengage. Fold legs down. Turn transfer bench
over and repeat for second set of legs. Remove
backrest, handle and soap dish if necessary.
CAUTION:
When entering or exiting shower or bath via the
transfer bench, make sure the seat is in one of
the locked positions.
WEIGHT CAPACITY: 300 LBS (136 KG)
Publicité
