Specific Safety Instructions - Build Worker BTP1800-254 Manuel D'utilisation

extension cord or reel with the earth core connected
to earth.
Always unwind any extension cords fully.
For extension cords up to 15 metres, use a wire
cross section of 1.5mm2 .
For extension cords over 15 metres, use a wire
cross section of 2.5mm2 .
Protect your extension cord from sharp objects,
excessive heat and damp or wet locations.
This power tool complies with National and
International
Standards and safety requirements. Repairs should
be carried only out by qualified persons using
original spare parts. Failure to do so may result in
considerable danger to the use.

SPECIFIC SAFETY INSTRUCTIONS

WARNING!
Some wood and wood type products especially
MDF (Medium Density Fibreboard) can produce
dust that can be hazardous to your health. We
recommend the use of an approved facemask
with replaceable filters when using and cleaning this
machine.
Ensure that the machine is disconnected from the
power supply before carrying out any adjustments
or maintenance.
Before turning the machine on for the first time
ensure that the blades are installed correctly.
Allow the machine to run up to full speed before
commencing any planing.
Observe the machine for excessive vibration.
This could indicate a poorly installed blade or out of
balance cutting head.
Never leave the machine running while unattended.
Always allow the machine to come to a complete
stop and disconnect from the power supply before
leaving the machine unattended.
Always wear safety goggles when operating the
planer.
Never use the machine without the safety guards in
position.
Never make passes greater than 2.5mm in depth.
Ensure that the work piece is free from any nails or
other foreign objects that could damage the planer
blades. Do not use work pieces that are: shorter
than 355mm, narrower than 19mm or wider than
254mm or less than 25mm thick.
Never insert your fingers into the dust chute for any
reason while the machine is in operation. The
cutting blades revolve at very high speeds.
Position yourself by the side of the machine in such
a way that the operation can be carried out without
having to over reach or reposition during operation.
Install the machine on a stable level surface before
operation.
COMPONENTS AND CONTROLS (PIC.1)
LOCATION
WARNING! This machine should not be used "free
standing".
When deciding on a suitable location for this
machine consideration must be given to the
maximum length of material to be planed. There
should be enough clearance to allow the work piece
to be fed into the machine safely and sufficient
clearance at the out feed end of the machine to
allow the work piece to be removed safely. This
machine must be mounted on a solid stable
workbench using 10mm hex Nuts and Bolts of a
suitable length to ensure secure fastening to your
workbench (Pic.2).
ASSEMBLY (PICS.3&4)
Attach the height adjustment handle to the pin on
the top cover of the machine and tighten the
crosshead bold (Pic.3). Ensure that the in feed and
out feed rollers are positioned correctly and are free
to rotate (Pic.4). If auxiliary support rollers are to
be used, they should be positioned at the correct
height, and approximately half the length of the
material being planed, away from the in feed and
out feed side of the machine e.g.. If the
material being planed is 3 mtr long, the auxiliary
support rollers should be positioned 1.5 mtr from the
in feed and out feed side of the machine.
STARTING AND STOPPING (PIC.5)
NO VOLTS EMERGENCY STOP SWITCH
This machine is fitted with a "No Volts Switch". In
the event of a mains power failure or if the mains
plug is removed from the mains supply socket
before the machine is switched off. The machine will
not re-start without warning when the mains supply
is restored or the mains plug is re-connected to the
mains supply, until the machine is switched ON at
the ON/OFF switch fitted to the machine. The switch
14