ChiQ L32G4500 Mode D'emploi page 19

Menu Operation
– LNB Type: Select the LNB type .
– LNB Power: Select the power supply type for the LNB.
– 22kHz: Select the 22KHz depending on the LNB type.
– Toneburst: You can choose one of two satellites. Used to choose proper device.
– DiSEqC1.0: You can choose one of four satellites . Used to choose proper device.
– DiSEqC1.1: You can choose one of sixteen satellites . Used to choose proper
device.
– Motor: Sets the positioned type between DiSEqC1.2and USALS.
When motor is set to DiSEqC1.2 or USALS:
Set Limit: Press the red button to set Limits to the scope of satellite Antenna rotation.
Move Continue: Rotates the antenna until the rotation has been completed or
Stopped manually.
Move Step: Rotates the antenna in accordance with the step value. Enables
the antenna make a fine adjustment.
Set West Limit: Set the west limit value。
Set East Limit：Set the East limit value.
Goto Reference: Drive antenna to zero position.
Disable Limit: Delete Limit settings. Allows the antenna to rotate over the full arc.
Cancel east limit and west limit.
Set position: Press the GREEN button to set position.
Move Auto: Rotates the antenna automatically.
Move Continue: Rotates the antenna until the rotation has been completed or
stopped manually.
Move Step: Rotates the antenna in accordance with the step value. Enables the
antenna make a finer adjustment.
Goto Position: Rotates the antenna to the stored satellite position.
Goto Reference: Drive antenna to zero position.
GotoX: Moves the antenna to the location specified by the Set Location.
When Motor is set to USALS:
Set Location: Press the yellow button to set Location.
Location: Longitude Direction, Longitude Angle, Latitude Direction, Latitude Angle
can be adjusted When the Location is set to Manual.
Longitude Direction: Sets the Longitude direction for the location.
Longitude Angle: Sets the Longitude angle for the location.
Latitude Direction: Sets the Latitude direction for the location.
Latitude Angle: Sets the Latitude angle for the location.
– Reset All : Satellite list, transponder list and some setting will be reset to the default
values. After reset all, you can re-set the county while Auto Tuning.
16