ChiQ L32G4500 Mode D'emploi page 18

Menu Operation
If you select Network Search, you can set up the frequency, Network ID and
symbol manually by pressing the button on the remote control. Quick Scan only
search DVBC digital programmes, can not search for ATV programmes.
If you select Full Scan, the Auto Tuning will search through all or appointed
frequencies to find available channels.
– Frequency: Enter a user-defined frequency. (Differs in each country)
– Network ID: Select the Network ID setting Mode among Auto or manual. When
Network is Manual, you can set up Network ID using the numeric buttons.
When you are satisfied with your setting, press ENTER button.
– Symbol: Selects the Symbol setting mode among Auto or Manual. When
Symbol is Manual, you can set up Symbol using the numeric buttons.
3. The TV will begin memorizing all of the available channels.
■ CADTV Manual Tuning
Frequency, Symbol and Modulation are needed in order to add a programme
correctly in DVB cable mode. Please inquire of the cable service provider about the
correct values.
※ When TV signals is Satellite.
■ Auto Tuning: Select the ENTER button to start Auto Tuning.
Satellite Setup
Satellite/ Transponder: Press the INDEX button to switch between the satellite
■
list and the corresponding transponder list.
Press the▲/▼button to select the satellite/transponder from the list.
CH+/CH-: Press the CH+/- button to page up or down the satellite/transponder
■
list.
Delete: Press the red button to delete the current satellite.
Edit: Press the green button to edit the current satellite.
Add: Press the yellow button to add a new satellite.
Scan: Press the blue button to enter sub-menu.
• Scan mode: Press the ◄/► buttons to select Scan Mode: Default, Blind Scan.
• Encrypted: Scan either free or all channels.
•
Service Type: Select the service type to scan.
CHANNEL
Antenna Type
Auto Tuning
ATV Manual Tuning
LCN Enable
Dynamic Rescan
Programme Edit
BISS Channel List
CI Information
Move Select
15
1 / 2
Satellite
On
On
Return