GE GDF510-640 Serie Manuel D'utilisation page 6

Getting started
Select Options
5
The light by the selected pad will be lit to indicate which Option has been selected.
Wash This option increases the temperature to help clean heavily soiled dishes and will increase the
Temp cycle time by 20 to 50 minutes. Option may be turned On or Off during the wash cycle. This
Boost option will also improve dry performance on the Normal cycle.
(on some
models)
Steam This option has several functions. Steam is introduced at the beginning of the cycle to help with
Sani (on heavily soiled and/or dried-on, bakedon soils and for sanitization of dishware along with improving dry
some performance by raising the water temperature in the final rinse. The cycle length will vary depending
models) on the temperature of your inlet water. This option MUST be selected PRIOR to starting the cycle.
Available with Heavy, AutoSense and Normal cycles.
NOTE: This option is monitored for sanitization requirements. If the cycle is interrupted during
or after the main wash portion or if the incoming water temperature is so low that adequate
water heating cannot be achieved, the sanitizing conditions may not be met. In these cases, the
Sanitized light will not illuminate at the end of the cycle. Utilizing this option will modify the cycle
to meet the requirements of Section 6, NSF 184 for soil removal and sanitization efficacy.
NOTE: NSF certified residential dishwashers are not intended for licensed food establishments.
Heated This option can be selected by pressing the Dry button once to illuminate the Heated light. This
Dry setting will greatly improve your dry performance for daily, regular or typical dishes. The heated dry
option will typically add 48
cycle. NOTE: The use of rinse aid can further enhance the dishwasher's drying performance.
Heated Dry was selected to rate
Dry Boost This option can be selected by pressing the Dry button twice to illuminate the Boost light. This
option will add additional time to your heated dry option, further enhancing the dishwasher's
drying performance for difficult to dry items. NOTE: The use of rinse aid can further enhance the
dishwasher's drying performance.
Heated Shuts off the
Dry Off the end of the cycle can improve drying performance. NOTE: The use of rinse aid can further
enhance the dishwasher's drying performance.
Bottle Jets This option increases the time that the bottle jets are on and may add up to 23 minutes to the
(on some cycle time. Use this to wash difficult to clean, dishwasher safe baby bottles, sport bottles, tall
models) coffee cups, etc. See use recommendations in the
Wash Selecting either the Upper or Lower Wash Zones will target dishwashing of just one rack. This
Zones will shorten the cycle time and conserve energy. This option should be used when dishes are
(on some placed in only one rack.
models)
Delay Delays the start of a wash cycle up to 8 to 12 hours depending on model. Press Delay Hours, to
Hours select the number of hours, then press Start one time and close door to begin countdown. The
(on some cycle will start once allotted time has expired.
models)
Control You can lock the controls to prevent selections from being made. You can also lock the controls
Lock after you have started a cycle to prevent cycle changes. For example, children cannot accidentally
start the dishwasher by pressing pads with this option selected.
To LOCK/UNLOCK the dishwasher control, depending on the model, press and hold the Dry
and Steam pads, or on some models the Select Cycle pad for 3 seconds. The Lock Controls
light, or on some models the Light and Rinse cycle lights will turn on to indicate the control is
locked and will turn off to indicate the control is unlocked.
6
minutes to your cycle time. This option is not available with the Rinse
the energy efficiency of this dishwasher.
drying option. Dishes air dry naturally and energy is saved. Opening the door at
Loading section.
49-55122-4