Publicité
Les langues disponibles
Les langues disponibles
WARNING!
Do NOT operate the blower/ventilator system without the filters in place, or with dirty, grease laden filters.
OPERATING CONTROLS:
Always activate the ventilator or when using appliances. For the best performance, turn on the blower a few minutes before
starting to cook to establish an airflow pattern within the room. Adjust the fan speed as needed. The left control adjusts the
halogen lights and the right control adjusts the blower.
ENERGY SAVING TIPS:
Eliminate air currents in the vicinity by shutting nearby windows and doors, turning off ceiling fans and adjusting the adjacent
heating and air conditioning outlets if necessary. Place your largest pans on the rear burners whenever possible. Clean filters
and grease laden surfaces often to improve efficiency. Always use lids on cookware to retain heat and moisture. Minimize the
amount of liquid used to cook food. Select cookware of proper size, material and construction for the cooking task being
performed.
CARE & CLEANING:
Proper cleaning is necessary to maintain performance and appearance, while also ensuring safe operation. The frequency of
cleaning should be according to the type and amount of cooking. Best results will be achieved by cleaning soiled components
as soon as possible. Filters must be cleaned regularly. Remove the filter(s) by grasping the D ring on the filter front and
pulling gently. Grasp the front of the filter to remove it. To reinstall the filter, place the back edge of the filter into the back
filter bracket. Lightly push the filter toward the back of the liner while pressing the front side upwards into place.
The filters may be cleaned by hand washing in hot water using a mild detergent solution or by placing in an automatic
dishwasher. Dry the filters before reusing.
CAUTION: Most common scrubber type pads will scratch the liner. If a commercially available stainless steel cleaner is
used, it is important to read the labels for chlorine compounds. Chlorine is a corrosive substance. If these compounds are
present, rinse thoroughly and dry with a soft lint-free cloth. Follow polish manufacturer's instructions. Always wipe stainless
steel surfaces with the grain. Never wipe across the grain. After cleaning, reinstall the filters carefully.
HALOGEN LIGHT BULBS:
Blowers are designed for MR16-GU10 50 watt halogen lamps. They can be purchased at most home or grocery stores, e.g.,
Lowe's, Home Depot, McCoy's, Menards or Ace True Value.
ELECTRICAL CONNECTION
IMPORTANT: Copy this page and the next for your electrical installer.
WARNING!
matches the ratings found on the appliance data label before proceeding. The complete appliance must be properly grounded
at all times when electrical power is applied. Do not ground the appliance with the neutral (white) house supply wire. A
separate ground wire must be utilized. Failure to complete electrical connections properly may result in damaged or non-
functional systems. Follow instructions carefully to ensure proper installation.
It is the owner's responsibility to ensure that a qualified person performs the electrical connection of this appliance. The
electrical installation, including minimum supply wire size, must comply with the National Electric Code ANSI/NFPA 70-1990
(or latest revision) and local codes and ordinances. A copy of this standard may be obtained from: National Fire Protection
Association, 1 Batterymarch Park, Quincy, Massachusetts 02269-9101
INSTRUCTIONS:
calculate amp ratings based on the product label found on the 01A/02A series module. Always observe local building codes.
Always use a dedicated circuit. Line load is calculated by adding the amperage of the halogen lights to the rated amperage of
the ventilator. If the ventilator is rated in watts rather than amps, divide the watts by 120 and this will give you the amperage
rating.
Installation Instructions, Revised 05/13/13
USE AND CARE
Ensure that the power supply is disconnected before proceeding. Verify that the power supply
A 15 to 20 amp electrical service is recommended for proper electrical supply. Before determining,
Publicité
