Jeulin ExAO-NG Manuel page 5

Foxy
Foxy Meter CO Sensor
2
Ref :
482 044
Change of adjustment phase
ENGLISH
1 General
This sensor, connected to CO
2 Use
This sensor can be used with any console in the Foxy range.
2.1 Connection to the Foxy console
- Place the sensor opposite the console connector
- Slide the connector following the console guide
- Push home until it clips in.
2.2 Use in stand-alone or connected mode
Calibration:
Important remarks:
For accurate quantitative measurements, the probe must be calibrated but
this is not essential every time it is used provided the probe/sensor
combination remains unchanged: the sensor stores the settings in its
memory.
Medium
Adjustment phase
Balancing the probe
Choice of medium
4
probe ref. 453 076, measures CO
2
in air or water.
2
Calibration
Direction of variation
Status of probe
Adjustment screw