Setup For Stick (Mma) Welding; Operation Environment; Operation Notices - Vector Welding ARC Serie Mode D'emploi

Operation
4.Current adjusting button
Clockwise rotate to enlarge the current, and anti-clockwise rotate to reduce the current.
5. Positive welding output terminal
The positive welding terminal is used to connect the welding output of the power source
to the appropriate welding accessory such as earth clamp. It is essential, however, that
the male plug is inserted and turned securely to achieve a sound electrical connection.
6. Negative welding output terminal
The negative welding terminal is used to connect the welding output of the power source
to the appropriate welding accessory such as electrode holder. It is essential, however,
that the male plug is inserted and turned securely to achieve a sound electrical
connection.
CAUTION
Loose welding terminal connections can cause overheating and result in the male plug
being fused in the bayonet terminal.

3.2 Setup for STICK (MMA) welding

For Alkaline Electrode,connect the electrode holder to the positive welding termimal
a n d c o n n e c t t h e w o r k l e a d t o t h e n e g a t i v e w e l d i n g t e r m i n a l , w h i l e f o r t h e A c i d
Electrode,please connect the electrode holder to the negative welding termimal and
connect the work lead to the positve welding terminal.If in doubt consult the electrode
manufacturer. Welding current flows from the Power Source via heavy duty bayonet type
terminals. It is essential, however, that the male plug is inserted and turned securely to
achieve a sound electrical connection. Select STICK mode with the process selection
control.
B e f o r e c o n n e c t i n g t h e w o r k c l a m p t o t h e w o r k a n d
inserting the electrode in the electrode holder make
WARNING sure the mains power supply is switched off.
Remove any packaging material prior to use. Do not
block the air vents at the front or rear of the Welding
CAUTION
Power Source.
L o o s e w e l d i n g t e r m i n a l c o n n e c t i o n s c a n c a u s e
overheating and result in the male plug being fused
CAUTION
in the bayonet terminal.
33
ARC SERIES EQUIPMENT ARC SERIES EQUIPMENT
Earth clamp

3.3 Operation environment

◆
Height above sea level is below 1000m.
◆ Operation temperature range: -10˚C~+40˚C.
◆
Relative humidity is below 90% (20˚C).
◆
Preferably site the machine some angles above the floor level, the maximum
angle does not exceed 15˚.
◆
The content of dust,acid,corrosive gas in the surrounding air or substance
can not exceed normal standard.
◆
Take care that there is sufficient ventilation during welding.There is at least
30cm free disstance between the machine and wall.

3.4 Operation notices

◆
Read safty instruction and Chapter 1 carefully before attempting to use this
equipment.
◆
Connect the ground wire the machine directly
Operation
power supply
ARC200G same
Connection method
Electrode holder
34