KTM Power Parts 76012935144 Guide Rapide page 6

6
- Join plug-in connector .
- Bond reed switch (in scope of supply) to rear frame as shown.
NOTE
Before bonding, ensure that the adhesive surface is clean and free
of grease.
Route the cable properly and secure with a cable tie. Ensure
that the cables are not kinked or pinched. Check the cable rout-
ing to ensure that there is no chafi ng.
- Bond reed magnet (in scope of supply) to passenger seat as
shown.
NOTE
Before bonding, ensure that the adhesive surface is clean and free
of grease.
Final steps
- Install the passenger seat (see Owner's Manual).
- Perform a function check of the alarm system in accordance with
the Owner's Manual.