SafeGuard Industrial Aramsco Syclone XL Manuel D'utilisation page 2

FIG A: PARTS IDENTIFICATION
FRONT
Drain hose
Power cord and
quick-connect.
drain hose
storage.
Humid air inlet.
Air filter.
Front panel. Remove to
access the pump and
coils for cleaning. See
Fig. B.
REAR
Integrated handle. Use the
red lever to lock handle
upright for use or down
for loading or storage.
Control panel.
Power cord
socket.
Drain hose quick-
connect.
Model serial
number label
Process (dehumidified)
air outlet.
NOTICE: Do not use the extended handle to lift the unit
off the ground horizontally. Do not use the extended
handle as an attachment point to strap the unit in a
vehicle for transport. These uses will place undue strain
on the handle attachment points in the housing.
07-02353A F588
Set up drain hose
This unit automatically pumps out water on a
regular basis. This dehumidifier is equipped
with a quick-connect fitting for attachment to
the provided drain hose located in the tray on
top of the unit. Unwrap the entire hose and
place the open end in a sink, drain, bucket or
outdoors – anywhere that water can drain out
safely. If you use a bucket or other container
for water collection, check it regularly to
prevent overflows.
NOTICE: Uncoil and straighten the entire
drain hose. Do not leave any part of the hose
coiled on the unit and do not place the end of
the hose higher than 20 ft. (6 m) above the
bottom of the unit. Also check for kinks or
other obstructions that might restrict the flow
of water. A kink or blockage will cause the unit
to turn off produce an ER9 error code. See
"Error Messages," below, for more
information.
Plug in electrical cord
The dehumidifier should be plugged into a
GFCI-protected 115 volt outlet rated for at
least 15 amps. Remove the cord from the
storage tray and uncoil it. Always plug the
cord firmly into the unit first, and then plug the
other end into a suitable electrical outlet.
Startup display and normal display modes
When unit is first plugged into AC power, the
control panel display will briefly cycle through
a series of readouts. This is part of the unit's
self-diagnosis procedure and no user
intervention is required.
Turn the unit on
The control panel has a display and a
touchpad with four keys. Press the ON/OFF to
turn the unit on. The unit will now go through a
compressor delay countdown (up to 60
seconds in duration) and a self-diagnostics
process, then switch to normal display
mode.
2 Aramsco