Connect Hose And Water Supply To Pump - Murray 020393-0 Mode D'emploi

Connect Hose and Water Supply to Pump

NOTICE: DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTE: Remove and discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses.
1. Uncoil high pressure hose and attach one end of hose
to base of spray gun. Tighten by hand.
WARNING: The high pressure stream of water that this
equipment produces can cut through skin and
its underlying tissues, leading to serious injury
and possible amputation.
• NEVER connect high pressure hose to nozzle extension.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• Always be certain spray gun, nozzles and accessories are
correctly attached.
2. Attach other end of high pressure hose to high
pressure outlet on pump. Tighten by hand.
3. Before connecting garden hose to water inlet, inspect
inlet screen (A). Clean screen if it contains debris or
have it replaced if damaged. DO NOT run pressure
washer if inlet screen is damaged.
4. Run water through your garden hose for 30 seconds to
IMPORTANT: DO NOT siphon standing water for the water
supply. Use ONLY cold water (less than 100°F).
NOTICE: Using a One Way Valve (vacuum breaker or check
valve) at pump inlet can cause pump or inlet connector
damage.
• There MUST be at least ten feet of unrestricted garden hose
between the pressure washer inlet and any device, such as a
vacuum breaker or check valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5. Connect the garden hose (not to exceed 50 feet in
• Always wear indirect vented (chemical splash) safety goggles
marked to comply with ANSI Z87.1 when using or in vicinity of
this equipment.
• NEVER substitute safety glasses or dry-condition goggles for
indirect vented safety goggles.
6. Turn ON the water, press red button (B) on the gun and
Checklist Before Starting Engine
Review the unit's assembly to ensure you have performed all
of the following.
1. Be sure to read the Operator Safety section and How to
2. Make sure handle is in place and secure.
3. Check that oil has been added to proper level in the
A
4. Add proper fuel to fuel tank.
5. Check for properly tightened hose connections.
6. Check to make sure there are no kinks, cuts, or damage
7. Provide a proper water supply at an adequate flow.
clean out any debris.
length) to the water inlet. Tighten by hand.
WARNING: Risk of eye injury.
Spray can splash back or propel objects.
squeeze the trigger to purge the pump system of air and
impurities.
B
Use Your Pressure Washer in Operation section before
using pressure washer.
engine crankcase.
to high pressure hose.
9