How To Use - DrinkMate 410 Manuel De L'utilisateur

HOW TO USE

NOTE: Only use specified CO2 carbonators, and
Drinkmate bottles. Never carbonate if drink bottle is
empty or not completely attached.
Remove back cover. Remove
seal and twist off cap from CO2
carbonator.
DRINK RECIPES: Refer to our website www.idrinkproducts.com and Drinkmate social media sites for
many recipes you can try. Please share your own favorite new drink recipes with all Drinkmate fans!
To install CO2 carbonator, insert
threaded part of carbonator into
unit receptacle and
hand-tighten. Replace back
cover.
Remove Fizz Infuser and bottle
assembly by pulling assembly
forward 45 degrees and then
sliding it off the countertop unit.
Remove Fizz Infuser from bottle
by rotating it counter-clockwise
and then pulling it up.
Fill carbonation bottle with
beverage you intend to
carbonate. Do not fill past the
maximum fill line.
Only use pulp-less beverages.
WARNING! Pulped beverages
may clog the pressure release
valve.