Removing The Side Panels - ZALMAN Z3 Iceberg Mode D'emploi

Z3 ICEBERG
I/O Ports
# Part
ⓐ
Power Button
ⓔ
USB 2.0 Port
ARGB 컨트롤러 및
※ How to control RGB LED
- LED colors & patterns can be changed by pressing the LED Button
on I/O ports.
- Long pressing on the LED Button for 6 seconds, RGB LED will be turn
off after blinking twice in white.
- Long pressing on the LED Button for 3 seconds, RGB will be
synchronized with motherboard after blinking once in white.
Press the LED Button again to desynchronize with motherboard.

1. Removing the side panels

8
# Part
ⓑ
HDD / Power LED
ⓕ
Headphone Jack
버튼은 "KOR"사양에는 미포함 되어 있습니다.
ⓗ
ARGB Connector
※ Caution : Please do not connect
ARGB fans more than 8pcs, otherwise it
may cause malfunction.
# Part
ⓒ
Reset Button
ⓖ
Microphone Jack
ARGB LED 1~4 / 3-Pin
ARGB LED Control Button / 2-Pin
- Connector to ARGB LED Control Button
Other Motherboards Sync / 3-Pin
- Connector to Motherboard
- Requires Motherboard that Supports RGB Sync
5V
DATA
GND
※ Caution: if Addressable 3 Pin connects to 12V header
instead of 5V header improperly, It may cause fatal
damages to the product by the overvoltage.
SATA Power / 15-Pin
- Connector to PSU
- Input : 5V
Connect the ARGB connector to the RGB hub
# Part
ⓓ
USB 3.0 Ports
ⓗ
LED Button
5V
DATA
GND
12V
Green
Red
Blue
PSU