Care And Maintenance - Eurotops 47176 Mode D'emploi

L 8100 / MG81000S
3) Regulating of Headband
Rotate the regulating wheel on both sides of helmet, regulate headband up
and down to comfortable angle, tighten regulating wheel and fix it.
Pull out regulating switch at back of headband, then rotate it left and right
to appropriate position, finally press regulating switch.
4) Use the LED light
Three LED lights are on front of helmet to ensure large uniform lighting area. Their lighting angles can
be freely regulated.
The brightness of LED lights can be switched between strong light and soft light to meet different
lighting requirements, thus protecting eyesight.
C. CARE AND MAINTENANCE
Clean the product only with a dry or slightly damp, lint-free cloth.
Do not use abrasive cleaners to clean the unit.
D. FEATURES
Materials: ABS and acrylic lenses
The European directive 2012/19/EC about electronic and electric waste, requires that you can't throw away defective
domestic appliance with common waste. Used device has to be collect separately to optimize the recuperation rate and the
recycling of the materials to reduce the impact on the health and the environment.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capacities, or
by persons lacking in experience or knowledge, unless they are supervised or instructed on the use of this apparatus by a
person responsible for their safety.Children should be supervised to ensure they do not play with this appliance.
Precision and precautions about the battery use
Throwing away a used battery in the environment or with household waste pollutes and avoids the recuperation of
o
reusable materials.
It is important to limit the battery consumption and to respect the following rules:
o

Favor alkaline battery (last longer than saline battery) and when it's possible use rechargeable battery.

Leave used batteries and accumulators in adapted containers that you can find in some retailers. In that way, metals
don't pollute the environment and the health.
Battery has to be inserted by respecting the polarity show on the apparel and the battery. An incorrect positioning
o
can damage the apparel, cause leaking and even provoke fire and the explosion of the battery.
To assure a good functioning, battery has to be in a good condition. If there is a problem, put new battery.
o
Never try to recharge battery not made for this. It could leak, warm up, cause fire or explode.
o
Replace all the battery at the same time. Never mix up alkaline battery with saline battery.
o
Used battery has to be removed.
o
Also, remove the battery if you're not using the apparel for a long time.
o
Never try to short-circuit the terminal of a battery.
o