Touch Operation - Legamaster eScreen 65EMD Guide D'installation Rapide

Touch Operation

No calibration is required for first-time use. However, the touch
system might need calibration over time or when for instance a
different resolution is used. Please find calibration instructions
below for the different operating systems:
Installation:
1. Connect the signal cable to the monitor and then turn on
the monitor
2. Connect one side of the USB cable (type-B USB connector) on
the monitor side (see "chapter 3, Signal Source Input"
for exact location)
3. Connect the other side of the USB cable (type-A USB connector)
to the computer
4. Turn the computer on
Windows 7&8 and Mac OSX Calibration Procedure
1. Install and run the TouchWin configuration program on the
computer
2. Press „Calibration"
3. A black screen with one red and eight white calibration points
appears
4. Tap the red calibration point with your finger or Legamaster
Ergonomic Stylus shortly.
5. The cursor will move to the next calibration point. Repeat
action 4 and move on to the next indicated calibration point
6. Repeat action 4 until you get to the last calibration point in the
lower right-hand corner
7. When you complete the nine-point calibration, a conformation
window appears. Click Done to accept the calibration; click
Cancel or do nothing (in which case the calibration window
automatically disappears after five seconds) to cancel the
calibration.
8