Operating The Monitor; Display Mode; Adjusting The Volume - Legamaster eScreen 65EMD Guide D'installation Rapide

4  Operating the monitor
The control panel of the monitor
 LED ON:
Power Status
Blue
Red
Blinking red
Blinking red and blue
Off
The Remote Control (RCU) Instructions
No. Function
1 Power
Source
2 Hot key select input source PC, HDMI (HDMI 1, 2 or 3
3 Menu
, , , 
Volume +
Volume -
4 Exit
Menu
Info
5 BLANC buttons
6 Freeze
Mute
Stereo
Sleep
Power ON-Stand
by Indicator
Remote Control
Receiver
Condition
Power on
Power off
Power saving mode
monitor starting up
AC off
Power on
Description
Turns the monitor On and Off
Select source (PC, HDMI 1,
HDMI 2, HDMI 3 or Displayport)
and DisplayPort), Component (n/a),
AV (n/a) - S-Video (n/a) - Scart (n/a)
Opens the monitor's on-screen
menu system. If the menu system
is already open, pressing this
button will select the previous
submenu
Navigates through submenus and
settings
Increases the sound volume
Decreases the sound volume
Closes the menu system
Open the menu
Current information
Not used
Freezes the current source image
Turns off the sound
Choose between stereo and mono
Enter sleep mode
1
3
6

Display Mode

Turning the monitor on
1. Correctly insert the power cord into the monitor and
into the power socket
2. Press the power button on the remote or front control panel.
Turning the monitor off
With the power on, press the power button on the remote or
front control panel to place the monitor in a standby mode. To
turn off power completely, disconnect the AC power cord from
the power outlet.

Adjusting the Volume

1. Using the remote, press the VOLUME- or VOLUME+ to increase
or decrease the volume.
2. Press the MUTE button to temporarily turn off all sound.
To restore the sound, press the MUTE button again.
Selecting the input source
1. Using the remote, press the desired source button (DisplayPort,
HDMI 3, HDMI 2, HDMI 1)
2. Or press SOURCE on the monitor keypad, and toggle the source
button until you have reached the desired source, and press
ENTER:
 VGA
 DisplayPort
 HDMI 3
 HDMI 2
 HDMI 1
3. If the monitor cannot find a source, a "No signal" message
will appear.
2
4
Battery insertion
7