Compressor Cleaning - Sunrise Medical 8650D Mode D'emploi

C o m p r e s s o r C l e a n i n g
CAUTION—This model is designed to operate utilizing
115V, 60Hz. Do not attempt to operate this
compressor on any other power source, as
damage to the motor may result.
7. To start the compressor, press the power
switch "On."
NOTE—Cold temperatures may cause a delayed motor
start-up. Should this occur, place the
compressor in a warmer room until the unit
reaches room temperature. Then press the
power switch again.
Compressor pressure may be increased by turning the
pressure adjustment knob in a clockwise direction
(knob must be pulled out to unlock) Figure 5. Pressure
is decreased by turning the pressure adjustment knob
in a counterclockwise direction. After adjusting the
pressure as specified by your physician or the
medication instructions, push adjustment knob to lock.
NOTE—For continuous use, do not exceed 50 psi
maximum pressure.
NOTE—In order for unit to register a correct pressure
gauge reading, nebulizer/tubing must be
connected to the compressor.

COMPRESSOR CLEANING

Be sure the power has been disconnected. Wipe the
compressor cabinet with a clean cloth and any
commercial disinfectant.
CAUTION—Do not submerge in water, as compressor
damage will result.
CAUTION—Do not gas sterilize.
E n g l i s h
Figure 5
5