Installing Software - 3com Wireless 8760 11a/b/g PoE Access Point Guide De Mise En Route

6. Checking the LED Indicators
When the Access Point is connected to power, LEDs indicate activity as follows:

7. Installing Software

The following applications and documents are included on the 3Com CD-ROM:
•
Wireless Infrastructure Device Manager
•
User manual
•
This Quick Start Guide
You need to install the Wireless Infrastructure Device Manager software (WIDMan) on your
computer to discover and configure the Access Point.
1
Turn on your computer.
2
Insert the 3Com Installation CD into the CD-ROM drive.
The CD menu appears. If it does not appear, you can start the Setup menu from the
Windows Start menu. For example: Start > Run > d:setup.exe.
3
On the menu, click Utilities.
4
On the next screen, double-click 3Com Wireless Infrastructure Device Manager and then
click Install to install it.
LED Color Indicates
Power Green Power On
Amber Flashing indicates a hardware failure,
or the system is booting.
Off Power Off
11a Green Indicates that 802.11a 5.0 GHz
wireless networking is enabled. If the
LED is flashing, the wireless link is OK
and data is being transmitted or
received.
Off The radio is off
11b/g Green Indicates that 802.11g 2.4 GHz
wireless networking is enabled. If the
LED is flashing, the wireless link is OK
and data is being transmitted or
received.
Off The radio is off
LAN Green Indicates a 10/100Base-T network is
detected at the Ethernet port. If the
LED is flashing, the link is OK and
data is being transmitted or received.
Off No link
8