weBoost Drive 4G-S Mode D'emploi page 5

Cellular signal booster
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Adjusting the Drive 4G-S Arms
To change arms, gently lift the arm upward until
the arm slides free from the Drive 4G-S.
To reposition arms, move the arm above a
different slot on the Drive 4G-S and gently slide
the arm down until the arm is firmly in place.
Troubleshooting &
Understanding the Light
The Signal Boost includes a indicator light on
the side of the Drive 4G-S. The indicator light
will ei her be green or red.
Green indicates that he booster is
powered and operating at maximum gain.
Solid Red indicates that the booster has
shut off on the associated frequencies to
prevent oscillation (feedback).
Green/red Blinking indicates that the
booster is operating at a reduced gain to
prevent oscillation (feedback).
Need help?
www.weboost.com
Fixing Red Light Issues
If one or more lights on the Signal Boost are
red:
1.
Make sure all connections are tight.
2.
Increase the distance between the outside
antenna and the Drive 4G-S, by moving
them horizontally and/or vertically farther
apart until the light change to green.
Remember to keep he antenna at least 6
inches from any window or sunroof.
3.
Follow the same steps for a green/red
blinking light until the light goes solid
green.
4.
If more separation is not possible and the
coverage of the booster is too small wi h a
green/red blinking light indicating reduced
gain, contact the weBoost Customer
Support Team for assistance:
866-294-1660.
Lights Off
1.
Check connections on he power supply
to see that it is firmly plugged into both the
Drive 4G-S and the power source.
2.
If using a DC power supply in your
vehicle, ensure the power supply is
properly inserted. Then check the 12 volt
power from the car socket and the fuse.
Replace the fuse if necessary.
3.
If using a power strip in a building, ensure
the power strip is plugged in and turned
on and that power is coming from the
outlet.
NOTE: The Signal Booster can be reset by
disconnecting and reconnec ing the power
supply.
For additional descrip ions on troubleshooting,
see the install video at weboost.com/us/
drive4G-Svideo .
Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
5

Publicité

Table des Matières
loading

Table des Matières