Gerreka ROC Serie Manuel D'instructions page 14

INSTALLATION OF THE ACTIVATOR
Assembly diagram
Drill a Ø12 mm hole in the blind axel (models N, NF, S, SF, SB and SBF) or a single Ø 7.75 mm hole ( models NR, NFR, SR, SFR).
Position the motor in the axel and tie the disc lock. The condenser does not need to be released for this operation.
Fit the M10x100 bushing screw to join the motor to the tube of the blind (models N, NF, S, SF, SB and SBF) or the M8x30 screw (models NR, NFR,
SR, SFR).
Fix the motor to the tube by tightening the screw which is to be found in the condenser area.
Introduce the semi crown through the free side of the motor mesh and at the stroke end. Turn and interlock it and introduce it into the second
semicrown. Join both of them together.
Fix the blind onto the motor.
If the motor has a brake, take the plastic caps off it.
14