Intec i-Starter 4.0 Mode D'emploi page 13

WARNING
1. Both clamps must be well connected to the battery poles or to the remote terminals.
They must be free of rust, dirt or sulphates.
2. If your car does not start after the third attempt, you'd better let the device cool
down properly to avoid irreparable damage. Search for other problems that may
prevent your car from starting.
3. DO NOT connect the two clamps together as this may cause sparks or fires.
4. DO NOT open the device to avoid fire risk.
5. Incorrect use of the device can irreparably damage the battery.
6. The guarantee does not apply to the battery as this is a consumable item.
7. The booster must always be recharged in well-ventilated places and away
from easily inflammable materials.
8. Non compliance with the above instructions may lead to serious damage of the
unit.
Furthermore:
• Always pay the utmost attention when using the device for engine starting
• Keep out of children's reach
• Do not keep in a humid place
• Do not soak in water
• Do not use in close proximity to inflammable liquids or in the presence of
inflammable gases
• Any intervention must be carried out by authorized personnel only
• Do not expose to heat sources
• Battery charging must be carried out at room temperature and only by using the
charger provided
• If the device is not used in compliance with the operational standards, leaking of
fluids may occur. Carefully avoid contact with eyes, skin and clothes. In case of
contact with eyes or skin, wash with plenty of water and see a doctor.
English
13