Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION-RELATED PRECAUTION
Before installing the unit, read and follow the following instructions.
¶ This unit can be installed on only one changer.
¶ This unit occupies two of the rear bays.
The rear bays where this unit can be installed are the odd-numbered rear bays.
¶ It is impossible to install another unit in 1 or more of this unit's rear bays (odd
numbered). Attempting to install another unit will cause a malfunction, so do not
attempt to do so.
INSTALLATION
For instructions on how to open the
a c c e s s d o o r s , s e e t h e o p e r a t i n g
instructions for the changer.
1. When inserting a unit, be sure to
place the unit on the changer guide
rails and push the unit in until the
lock lever on the unit shifts to the
locked position. Maybe you can hear
a clicking sound then.
Disc flip unit
Lock lever
When a unit is to be removed from the
changer, flip the lock lever to the released
position and then pull the unit out from the
changer.
2. Connect the changer interface cable.
NOTE:
Connect the changer interface cable to the
Guide rails
connector corresponding to the bay in which
the units have been installed. (Note that labels
are affixed to connectors indicating the
corresponding bay number.) Note that it is
extremely important to do this, as connecting
the changer interface cable to a neighboring bay
will result in damage to discs and the disc
transport mechanism.
Warning about static electricity
Always be sure never to touch the
contacts or ports when operating units.
Also be sure to touch a metallic surface
on the changer before installing
additional units to the changer.
Changer interface cable
<DRC1287> En
5
Publicité
Table des Matières
