Hameg Instruments HZ56-2 Manuel page 12

– To avoid electric shock, use caution during installation
and use of this product; high voltages and currents may
be present in circuit under test.
– Do not use the product if damaged. Always connect pro-
be to display device before it is installed around the con-
ductor.
– Always ensure the probe is removed from any live elec-
tric circuit, and leads are disconnected before removing
the battery cover.
– Use the Current Probe only as specifi ed in the operating
instructions; otherwise the current probe's safety fea-
tures may not protect you.
– Adhere to local and national safety codes. Individual pro-
tective equipment must be used to prevent the shock and
arc blast injury where hazardous live conductors are ex-
posed.
– Do not hold the Current Probe anywhere beyond the tac-
tile indicator.
– Before each use, inspect the Current Probe. Look for
cracks or missing portions of the Current Probe housing
or output cable insulation. Also look for loose or wea-
kened components. Pay particular attention to the insu-
lation surrounding the jaws.
– Use caution when working with voltages above 60 V
30 V rms or 42 V
AC
hazard.
– Use of this equipment is designed to protect against
transients in equipment in fi xed equipment installations,
such as distribution panels., feeders and short branch
circuits, and lighting systems in large buildings.
– Use of this equipment in a manner not specifi ed herein
may impair the protection provided by the equipment.
– CAT III equipment is designed to protect against the tran-
sients in the equipment in fi xed equipment installations,
such as distribution panels, feeders and short branch
circuits, and the lighting systems in large buildings.
peak. Such voltages pose a shock
AC
Subject to change without notice
,
DC
13