Inogen BA-107 Mode D'emploi page 6

NOTE
Under certain conditions (see Technical Specifications) the Universal Power Supply
may shut down. The green LED will blink or will no longer be illuminated. If this
occurs, disconnect the Power Supply for at least 10 seconds and reconnect.
DC Input Cable Fuse Replacement
The Cigarette Lighter DC Power Plug contains a fuse. If the DC Input Cable is being used with
a known good power source and the power supply is not operative (no output power and the
green LED is not illuminated), the fuse may need to be replaced.
To replace the fuse, follow these instructions and refer to the photograph below.
1. Remove the tip by unscrewing the retainer. Use a tool if necessary.
2. Remove the retainer, tip and fuse.
3. The spring should remain inside the Cigarette Lighter Adapter housing. If the spring is
removed, make sure to replace the spring first before inserting the replacement fuse.
4. Install a replacement fuse, Inogen RP#125 (BUSS MDA-12)* and reassemble the tip.
Ensure the retainer ring is properly seated and tightened.
Cigarette Adapter Plug
CAUTION For continued protection against risk of fire, only use fuse specified.
Cleaning
Wipe the surface using a slightly dampened cloth with mild detergent. Do not immerse the unit.
Do not clean the unit with isopropyl alcohol or other solvents.
*Contact Inogen Customer Care for assistance.
Fuse Retainer Tip
Retainer