Inogen BA-107 Mode D'emploi page 4

OPERATING INSTRUCTIONS
Ensure the Power Supply is in a well ventilated location as it relies on air circulation for heat
dissipation. It is normal for the Power Supply to be warm during operation.
For Use At Home With AC Power
For operation of the Power Supply using an AC power source, follow these instructions:
1. Connect the AC Input to the Power Supply.
2. Connect the AC Power Plug to the power source and connect the Power Output Plug to the
Inogen One. The green LED will be illuminated, indicating the Power Supply has input power.
NOTE It is not recommended to use an AC plug adapter with the Universal Power Supply.
Use Inogen specified AC Power Input cables for international use.
For Use In Automobile/RV/Boat
For operation of the Power Supply using a DC power source, follow these instructions:
1. Connect the DC Input to the Power Supply.
2. Connect the DC Power Plug (Cigarette Lighter Adapter) to the power source and connect
the Power Output Plug to the Inogen One. The green LED will be illuminated, indicating the
Power Supply has input power.
3. The plug should insert into the socket without excessive force and securely remain in place.
The Cigarette Lighter Adapter comes with a slide switch pre-adjusted to the "narrow"
position. This will fit most automobile cigarette lighter sockets. If the Cigarette Lighter
Adapter is loose in the socket, adjust the switch to the "wide" position.
4. Ensure that the automobile power socket is adequately fused for the Inogen One power
requirements (minimum 15 Amp).