Battipav Queen 818 Mode D'emploi page 19

Battipav srl
CAUTION
In particular cases, it may be necessary to use a
basin to recover the cooling water.
If so, it is recommended to use a basin with the
following dimensions:
L 50 cm, P 60 cm, H 10 cm
BLADE ASSEMBLY / DISASSEMBLY
Remove the blade guard.
Use the 4 mm. Allen wrench to hold the motor
6
shaft.
Unscrew the blade flange block nut with the 19
mm wrench.
CAUTION
After removing the blade, clean the blade flange
thoroughly and check for wear.
Lubricate surfaces with fine oil, then fit the blade.
CHECK DAMAGED PARTS
Before further use of tool, it should be carefully
checked to determine that it will operate properly and
perform its intended function.
For diamond blade disassembly, perform the
opposite operations.
CONNECTING TO POWER SUPPLY
CAUTION
The machine is to be connected to the power supply
by a residual current circuit breaker (RCCB) with the
following characteristics:
RCCB In 10 A Id 30 mA
N.B. To ensure correct functioning, periodically
check the efficiency of RCCBs by pressing the
push-button on the front of the device.
• Make sure that the section of the power supply
cable cores has been measured according to the
starting current and its length.
For cables up to 50 m long, a section of 2.5 mm
is enough.
• Before connecting the machine to the power
socket, check that the power supply voltage
corresponds to that shown on the plate on the
machine.
• The machine must be connected to an effective
earth wire. In case of doubt, do not connect the
machine.
CONTROL DEVICES
CAUTION
The QUEEN machine is equipped with a control
7
board made up of:
1) START BUTTON: (GREEN COLOUR)
Press the button fully to activate machine starting.
2) REGULAR STOP BUTTON: (RED COLOUR)
Press the button fully to activate machine stop.
3) DEVICE FOR DISCONNECTION FROM THE
MAINS (Power supply cable with plug):
Machine power supply point.
CUTTING ON THE TABLE
CAUTION
BEFORE STARTING THE CUTTING OPERATIONS,
THE OPERATOR MUST MAKE SURE THAT AT
LEAST 150 cm ARE LEFT FREE AROUND THE
MACHINE (See picture 8).
IN ORDER TO WORK IN SAFETY CONDITIONS,
DO NOT LET OTHER PEOPLE REMAIN NEAR THE
MACHINE DURING THE CUTTING OPERATIONS.
GB
2
19