Technical Data - Battipav Queen 818 Mode D'emploi

GB

TECHNICAL DATA

Voltage:
Power:
Admissible working conditions:
INTERMITTENT - S6-25% SERVICE
Rotation speed:
Condenser:
Capacitor:
Tool:
CONTINUOUS CROWN DIAMOND BLADE WET
Recommended use:
CERAMIC, SINGLE-FIRED CERAMIC, COTTO AND
MARBLE (max. thickness 1-1.5 cm)
Sound:
LOADLESS VALUES
Lw
Lw
UNDER LOAD VALUES
Lpm
Lpm
The noise emitted by this machine was measured on
production samples in compliance with ISO 3745-77
standards.
The machine was positioned on an H800 (mm)
auxiliary table.
The samples comprised 314x314x8 mm single-fired
tiles, mod. P3T287 1200°C. K = 2, \[ dB ], pr EN 848 - 1
18
230V 50/60Hz.~
30 s under load running
90 s loadless functioningt
2800/3400 min-1
CUTTING
69,2 [dBW(A)] 0,0 [mW(A)]
100,2 [dBW(A)] 14,3 [mW(A)]
62,7 [dB(A)] 62,7 [dB(C)max]
92,0 [dB(A)] 100,7 [dB(C)max]
INSTALLATION
TRANSPORT
550W
3 The QUEEN machine can be easily moved by
using the side handle.
POSITIONING
8 µF
Remove the machine from the packaging and check
5 l
that no parts have been damaged.
Place the machine on a stable surface free of other
material.
CAUTION
Position the blade guard approximately half a
4
centimetre above the tile surface through the
knob.
Lock the blade guard in position by fully
tightening the screw illustrated in the figure.
CHECKING BEFORE USE
CAUTION
THE MACHINE MOD. 818 HAS BEEN DESIGNED
FOR WORKING EXCLUSIVELY WITH WATER.
5 Before and during cutting operations, make
sure that the water level is the same as the one
indicated in the relevant label located on the
machine side.
Fill or top up the basin directly, as shown in the
figure.
Battipav srl