Lumilight Led - Zephyr Siena ZSI-E30CS Guide D'utilisation, D'entretien Et D'installation

Maintenance
Installing the Grease Filters (FIG. G):
1. Pull down on filter latch to release the filter tabs.
2. Pull down on front of filter to remove the grease filters.

LumiLight LED

In the unlikely event that your LumiLight LED fails, please
contact Zephyr to order replacement parts.
See the list of parts and accessories page for part numbers
and contact information.
LED Removal (FIG. H):
1. Remove grease filters.
2. Remove the side panels (if applicable) and remove the
light panel.
3. Disconnect LED light quick connector.
4. Push in the two side clips on the ends of the LED light.
5. Push LED light through the light panel opening.
24 Siena Use, Care, and Installation Guide
C O R E
S I E N A
WA L L
FIG. G
Push the clip
FIG. H