Worx WX840 Notice Originale page 11

ASSEMBLY
Installing the belt hook
NOTE: The belt hook can be
installed on the left or right side
of the nail gun.
Loading the brad nails/crown
staples
NOTE: Keep pressing the
magazine release button
when opening or closing the
magazine.
WARNING: Keep the tool
pointed away from
yourself and others when
loading nails. Failure to do so
could result in possible serious
personal injury.
OPERATION
Selecting the nailing mode
Single sequential actuation
mode:
Contact actuation mode:
WARNING: The nail gun
will not function properly
if the selector is not securely
seated in either position. Always
assure the selector is seated
properly to avoid an unexpected
nail discharge and possible
serious personal injury.
Using the on/off switch in two
different modes
Keep pressing the on/off switch
when moving the tool in the
contact actuation mode as
shown in Fig. E2.
NOTE: The nail gun will be
functioned only when pressing
the switch and pushing the
workpiece contact against the
work surface at the same time.
WARNING: Never wedge or
hold back the workpiece contact
mechanism during operation of
the tool. Doing so could result in
possible serious injury.
Drive depth adjustment
NOTE: Drive a test nail after
each adjustment until the
desired depth is set.
LED worklight
NOTE: The LED Worklights
provide feedback to indicate
whether the battery pack is
charged sufficiently and/or if the
tool is functioning properly.
20V Cordless 18 gauge Nail/Staple Gun EN
Removing a jammed nail
Try to operate the tool for two
more times to confirm the nail is
jammed.
See Fig. B
first.
• Remove the nail and keep the
magazine open.
• The nail jam can be freed by
inserting a flat blade screwdriver
into the tip of the driving
mechanism and push it back.
See Fig. C1,
• Be sure the cover is closed and
C2, C3
the screws are tighten before
using the tool again.
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
See Fig. D
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
See Fig. E1, E2
See Fig. F
See Fig. G
WARNING: Always
remove the battery pack
See Fig. H1,
H2, H3
11