Battery Installation; Start The Smart Bot - Xtrem Bots SMART BOT Manuel D'utilisateur

3. batteries installation
in the transmitter
1. Use a philips' head screw to open the butt on cell gate of controller.
2. Put 2 x 1.5V "AA" batt eries inside the batt ery box.
3. Put the gate back and use a screw to ti ghten the gate.
in the robot
Robot batt ery is into the back of the Smart Bot.
To charge Li-Po batt ery, please insert the USB port provided USB
charging cable to anyone USB port of power pack, mobile charger, car
charger or computer.
Switch OFF the robot before charging. A light in the robot will be
turned on during the chargins process; when the robot is fully charged
the light will turn off .
The charging ti me is about 2 hours and the playing ti me is about 3
hours.

4. start the Smart Bot

Switch on the ON/OFF butt on on the front of the Smart Bot (1).
The Smart Bot introduce himself performing some movements and
sounds.
NOTE: The robot should stay on the fl oor.
(1)
6