Troubleshooting And Support - Tangent Danmark Classic BT Mode D'emploi

PAIRING WITH BLUETOOTH DEVICE
Bluetooth Speaker can pair with most Bluetooth 2.0 & 2.1 devices. Pairing may vary by device.
Consult your Bluetooth device's owner's manual for pairing instructions.
1. Press "Standby" key to switch on the unit
2. Select [BT] key with the remote control. The LED light will go Super white.
3. Press and hold "PAIR" key for 3 seconds until consecutive "beep" sound is played, the Bluetooth
Super White LED would flashing to wait for your Blue-tooth device pairing.
4. Turn ON your Bluetooth device (e.g. Smart Phone) setting, "TANGENT CLASSIC" would be shown at
your device Bluetooth list.
5. Connect your device to the BT Speaker with Bluetooth, your device menu would show "Connected",
the Bluetooth LED would keep ON at Super white when pairing success.
6. You can play your music wirelessly with the BT Speaker.
Remark:
For mobile with Bluetooth 2.0, its request to enter pass code during pairing, press 0000
The BT speaker can remember up to 8 Bluetooth devices, to clear the memory, under pairing mode, press
"Play/Pause/Pair" key twice (with 1 second interval) until a "Beep" sound come out. After memory clear,then
press "PLAY/PAUSE/PAIR" key to go to pairing mode , you need to do the pair step with your phone again.
*Operating range of Bluetooth audio is up to 10 meters. (Measured in open space. Walls and structures may
affect range of device.)
Auxiliary Audio Operation
1. Connect a media player to the aux-in jack on the back panel of the unit.
2. Select [Aux] key with the remote control. The LED light will go Super white.
3. Adjust the volume to fit your need.
4. In Aux mode, operate your audio device directly for playback features.
Adjusting Sound Effect
Press the POP, JAZZ, ROCK, CLASSIC or FLAT buttons on the remote control to select desired music mode.
Auto standby
If the unit volume is close to mute or idle for 20 minutes, it will automatically switch to STANDBY mode
CHARGING OTHER DEVICES
• Connected with power adaptor with Speaker DC in jack
• Plug one end of the USB cable at the back of your unit, plug the other end of the USB cable into
a USB port on your other devices to made for USB charging.

TROUBLESHOOTING AND SUPPORT

1. If the system does not work as expected, first carefully read this manual.
2. No operation: Check power adaptor and that mains power has been turned on.
3. If still not successful, contact your TANGENT customer support.