3M Peltor FL5205 Mode D'emploi page 4

EN
PELTOR ADAPTER FL5000
3M Peltor FL52xx adapters are in conformity with the requirements set out in the EMC directive
2004/108/EC. The equipment has been tested in accordance with EN61000-4-3:2006
FL5230 are tested and approved in accordance with the ATEX directive 94/9/EC and has a
EC-type examination certificate 09ATEX1116, 09ATEX1177, 09ATEX1329 Nemko 09 ATEX
1093 issued by NEMKO, Gaustadalléen 30, 0314, Oslo, Norway Notified body 0470.
The equipment has been tested and approved in accordance with the standards EN 60079-
0:2006, EN 60079-11:2007.
The equipment is CE marked.
FL52xx are in conformity with the IEC Ex Scheme and a certificate is available for download
from http://www.iecex.com.
Read these instructions carefully to get the most out of your Peltor product.
CHARACTERISTICS
Peltor's FL5000 adapter series offers the optimum adaptation of Peltor headsets to most
communication radios on the market.
Design
The adapter is enclosed in a functional, watertight, sturdy casing with no protruding parts. The
unit fits easily in your hand, but is also easy to wear attached to your clothing, without being
in the way or snagging on anything.
On the back of the adapter is a sturdy clamp (A), which can be twisted 360°, making the adapter
as convenient and flexible as possible in all situations. The clamp is removable if you do not
need to secure the adapter. The adapter also has an attachment loop (B), which can be used
to secure it when not using the clamp.
PTT button (C)
The watertight PTT button (Push To Talk) is made of a special, soft plastic. It is located on the
front of the unit and is designed for easy access with the right or left hand, even with heavy
gloves. The PTT button has a pressure point that indicates the on and off positions.
Connector cord
The outgoing cord (D) has a contact for a communication radio or mobile telephone. The cord
has a flexible, rugged reinforcement where it attaches to the adapter.
Headset contact
The adapter has a sturdy chassis jack (E) of Peltor's standard type, J11, for connecting Peltor
headsets. The whole adapter, particularly the jack, is designed to prevent moisture from
4