Olymp NC 450 Mode D'emploi page 15

When the bank notes counted are removed from the
output tray, the quantity count in the top display is
reset to X 0 and the bottom display displays the quan­
tity.
Adding
If several bundles of bank notes are stacked in the
infeed tray one after the other, counting continues
even if the bank notes already counted are removed
from the output tray.
Æ Press the ADD button
Ê The Add function is activated/deactivated.
Batch
This function causes counting to stop when the preset
quantity of bank notes has been counted. If the
counted batch of bank notes is removed from the out­
put tray, the display is reset to
counted.
The quantity of bank notes can be set to any number
1 999
between and . The preset quantity appears in
the bottom display.
If the infeed tray becomes empty before reaching the
preset quantity, BATCH flashes in the display. When
more bank notes are then inserted in the infeed tray,
the process is resumed.
Æ Press the BATCH button.
Ê BATCH flashes in the display. The preset quantity
100
appears in the bottom display.
Æ Use the digit buttons to enter the quantity you want
counted.
Ê The quantity entered appears in the bottom dis­
play.
X 0
and the next batch is
Sorting
With this function, which is always activated, the first
bank note is used as a reference for those following.
If the machine detects a bank note which deviates
from the reference note, the machine stops.
pears in the display, the background of which turns
red. The deviating bank note can be removed.
Whether the removed bank note should be counted
or not can be defined in the settings (refer to Set­
tings).
Settings
The sensitivity of the sensor and other parameters
can be modified using the respective Settings func­
tion.
Æ Press the SET button for a few seconds until the
acoustic signal stops.
Ê
d05 C5 100
and
d05 represents the current value of the memory seg­
ment C5 100 . You can change the value using the
arrow buttons.
Æ Press the SET button again.
Ê The next memory segment appears together with
the value.
After pressing the SET button for the last memory
segment you exit from Setting function.
G
appear in the display.
d
ap­
15