Introduction; Unpacking And Assembling Of The Microscope - OPTIKA MICROSCOPES STEREO Manuel D'instructions

2.0 InTROduCTIOn

The OPTIKA microscopes sTErEO series are high-performance stereo microscopes with a large possibility
of choice between various models with fixed magnification or rotable objective.
Total magnification ranges from 5x to 80x depending on the eyepieces (standard or optional).
These microscopes are suitable to analyze a variety of objects in D, for industrial, biological or educational
applications.
using the rotable objective (sT-0/40/45) you can change the magnification keeping a perfect parfocality (the
focus is kept when changing the magnification) and a perfect centering of the field.
Depending on the model, the binocular head can be fixed or 60° rotating.
Connect the mains plug into the socket at the base
Make sure, before you turn the illumination on, that the voltage selector is set to the mains voltage for
your region.
The power cord should be used only on network sockets equipped with adequate grounding.
Contact a technician to check the state of your electrical system. If there is no need to install additional
accessories, the instrument is now ready for use. Once positioned and installed with the necessary
components, the microscope is ready to be used. your microscope is a laboratory instrument desi-
gned to last. handle it always carefully and avoid abrupt vibrations or shocks. Always disconnect the
power cable from the microscope when not in use for long time, while you clean it or when you perform
any maintenance.
AVOId dISASSEMBLIng ThE InSTRuMEnT
Do not disassemble the instrument. This entails the cancellation of the warranty and may cause
malfunction.

3.0 unPACKIng And ASSEMBLIng Of ThE MICROSCOPE

The components for stereo series are shipped detached for protection.
Open the styrofoam protection with care and do not leave any components attached to the packing being
removed.
normally this series is shipped ready to be used and you have only to put the eyepieces into their tube.
If damage occurs during the transport please contact immediately both the carrier and your supplier.
Page 5