Adjusting Or Replacing Brushroll; Replacing Edge Brush; Replacing Light Bulbs - Oreck Classic Pro Mode D'emploi

Adjusting or Replacing Brushroll

CA TION To reduce the isk of in
Your Oreck Vacuum has a brushroll that can be replaced after heavy use for improved performance.
15
Remove the baseplate by removing 5 screws. Then, remove the belt and brushroll from the housing.
16
Snap the new brushroll into place.
17
Reassemble the belt.
15
Reassemble the baseplate.
If a previous adjustment has already been made and bristle height does not extend above the baseplate, a new brush assembly should be ordered.
15

Replacing Edge Brush

CAUTION: To reduce the risk of injury from moving parts, unplug before servicing.
Turn the power head over. With baseplate facing up, remove the screw located in the center of each edge brush.
Remove both edge brushes and replace with new ones. Replace both screws and tighten.

Replacing Light Bulbs

WARNING: To reduce the risk of electric shock, unplug before cleaning or servicing.
15
Remove the baseplate by removing 5 screws.
18
Remove the belt from the brushroll pulley. Then, remove the brushroll from the housing.
19
Remove the fascia by removing 2 screws.
20 Rotate fascia away from the power head and lift it away.
21 Pull burned out bulb from holder and replace with new bulb.
Reassemble the fascia.
20
Reassemble the brushroll and belt.
18
Reassemble the baseplate.
15
19
E N G L I
y from moving par s
16
20
7
S H
n lug e ore se vicing
17
21 22