Safety Instructions - Zanussi ZRX51100WA Notice D'utilisation

• Do not damage the refrigerant circuit.
• Do not use electrical appliances inside the food storage com-
partments of the appliance, unless they are of the type recom-
mended by the manufacturer.
• Do not use water spray and steam to clean the appliance.
• Clean the appliance with a moist soft cloth. Only use neutral de-
tergents. Do not use abrasive products, abrasive cleaning pads,
solvents or metal objects.
• Do not store explosive substances such as aerosol cans with a
flammable propellant in this appliance.
• If the supply cord is damaged, it must be replaced by the manu-
facturer, its service agent or similarlyqualified persons in order to
avoid a hazard.
• If the appliance is equipped with an Ice maker or a water dis-
penser, fill them with potable water only.
• If the appliance requires a water connection, connect it to pota-
ble water supply only.
• The inlet water pressure (minimum and maximum)must be be-
tween 1 bar (0,1 MPa) and 10 bar (1 MPa)

Safety Instructions

Installation
WARNING!
Only a qualified person must install this
appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied
with the appliance.
• Always be careful when you move the ap-
pliance because it is heavy. Always wear
safety gloves.
• Make sure the air can circulate around the
appliance.
• Wait at least 4 hours before connecting
the appliance to the power supply. This
is to allow the oil to flow back in the
compressor.
• Do not install the appliance close to
radiators or cookers, oven or hobs.
• The rear of the appliance must stand
against the wall.
www.zanussi.com
• Do not install the appliance where there is
direct sunlight.
• Do not install this appliance in areas that
are too humid or too cold, such as the
construction appendices, garages or wine
cellars.
Electrical connection
WARNING!
Risk of fire and electrical shock.
• The appliance must be earthed.
• All electrical connections should be made
by a qualified electrician.
• Make sure that the electrical information on
the rating plate agrees with the power sup-
ply. If not, contact an electrician.
• Always use a correctly installed shockproof
socket.
• Do not use multi-plug adapters and exten-
sion cables.
• Make sure not to cause damage to the
13