Samsung RH25H5611SR Mode D'emploi page 12

2. Separate the water supply line from
the refrigerator
1. Remove one or two water lines, depending on
the model, by pressing each coupler ( 1 ) and
pulling the water lines ( 2 ) away.
CAUTION
Do not cut the water line.
Gently separate it from the coupler.
3. Remove the freezer door
A few things to mention first.
• Make sure that you lift the door straight up so
the hinges are not bent or broken.
• Be careful not to pinch the water tubing and
wire harness on the door.
• Place doors on a protected surface to prevent
scratching or damage.
• Is necessary, have two people disassemble the
doors.
DA68-02981J-00.indb 12
1. With the Freezer door closed, remove the
upper hinge cover ( 1 ) using a screwdriver,
and then disconnect the wires by gently pulling
them apart ( 2 ).
(1)
Be careful not to damage the sensor
(1)
harness with the hinge cover.
(2)
2. Remove the hinge bolts ( 3 ) with a 10 mm
Socket Wrench.
Remove the ground screw ( 4 ) by turning it
counter-clockwise.
Take off the upper hinge ( 5 ) in the direction of
the arrow.
Take care that the door does not fall on you.
3. Open the Freezer door, and then remove the
door from the lower hinge ( 6 ) by carefully lifting
it up ( 7 ).
English - 12
(2)
(4)
(3)
(5)
(7)
(6)
Pressing
14. 11. 6. 2:05