Hotel Mode - Grandin LD49CGB18 Notice D'utilisation

Menu Operation
Press the SOURCE button to display the Source Menu, then press 2012 to
enter into the Hotel Mode to adjust the relative settings.

- Hotel Mode

Press the▲/▼buttons to select Hotel Mode, and then
press button to set On or Off.
◄/►
NOTE:
 The following settings work only when Hotel Mode is
set to be On.
- On Source
Set the default signal source by pressing the ◄/► buttons.
(The default signal source will be displayed when the TV
is turned on.)
- On Channel
Set the default channel by pressing the ◄/► buttons.
(The default channel will be displayed when the TV is
turned on.).
- On Volume
Set the default volume by pressing the ◄/► buttons. (The default volume is the
volume when the TV is turned on. Remember the default volume should be less than
the maximum volume).
- Max Volume
Set max volume by pressing the ◄/► buttons. When the max volume is lower than
the default volume, the max volume is the priority.
- Export to USB
You can export all current channel information (including channel number, channel
name, frequency, etc.) into the U disk, as the channel information backup for this unit.
- Import from USB
If you cannot restore the initial channel information after sort, move, skip, lock etc.
operations, you can import the channel information from the USB.
• First, insert a USB memory device into the USB port.
• Press the SOURCE button to call up the signal source selection menu. Use the ▲/▼
to highlight USB, and the press ENTER button to access the USB mode. (Alternatively,
Press the DMP button on the remote control to enter the USB mode)
• You may also use the signal source selection menu to exit from the USB mode.
NOTE:
 Special USB device may be not or well supported.
 USB max. Load: DC5V 500mA.
Hotel Mode
USB Operation
27
Hotel Mode
On
On Source
Air
On Channel
2
On Volume
30
Max Volume 60
Export to USB
Import from USB
Select Return