Table Connector - VS 901 Serie Instructions De Montage

(1)
(6)
(7)
8. 90° table connector.
Adjust adjusting part (1), depending on the available table
depth (2), and secure with washers and M6x25 mm self-
tapping cheese-head screws (5).
Slide connecting element (3) sideways into the cross-mem-
ber of add-on table (4). Screw on the connecting element
with washers and M6x25 mm cheese-head screws (5).
(2)
(5)
(11)
(9)
(3)
(9)
(4)
Slide adjusting part (1) over the cross-member of table (6).
Push the tables together and align. Screw down adjusting
part (1) with two washers and M6x60 mm cheese-head
screws (7). Adjust adjustable glide elements (8) so that
connecting disks (9) support the table tops.
Screw connecting disks (9) each with two 5x20 mm chip-
board screws (11) to the table top.
(8)
(11)
(5)
31